GAUGE CLUSTER INSTALLATION GUIDE 94-97 Honda Accord
*Please read this all the way through before doing this install!*
We will not be held responsible for any mistakes, problems, or damage done to any part of your car. Follow this install guide carefully, and you should have no problems. If you are unsure about ANYTHING, please email us. We will help you out to the best of our ability. |
Here Is What You Will Need: |
- Phillips head screw driver - Flat head screw driver
|
Follow the steps in the Climate Control Install Guide to remove the trim piece and get to the gauge cluster.
Remove the 4 screws that hold in the gauge cluster
Pull the top of the gauge cluster toward you to reveal 3 wire harnesses. Disconnect the harnesses and remove the gauge cluster. If you have an alarm, the alarm computer will think the doors are closed once you remove the wire harnesses and the alarm will turn on. So have your keys handy.
Remove the bulbs shown by the red arrows in the picture below and install the smaller wedge LED that is included in the kit.
Remove the bulbs shown by the arrows in the picture below. Install a small wedge where the blue arrow is pointing and the larger radial LEDs in the locations designated by the red arrows.
Remove the two screws that are above the stereo holding in the climate control. You may have to remove the stereo. The picture below points to where the screws are located.
Now you have to test the gauge cluster. Reconnect the 3 wire harnesses and be sure you have the dimmer button connected and turn on the park lights. If any LEDs do not light up, simply rotate them 180 degrees and test again. The best way to rotate them is: 1. Unlock the LED and plastic base - approx 1/4 turn counter clockwise so it can be removed. 2. Pull the LED and base out of the hole just enough to turn it 1/2 a turn (180 degrees) 3. Put it back in the hole 4. Twist it to lock it in (approx 1/4 turn clockwise).
|