LEDautomotive.com

  • LED Technology

    LEDs are the future of automotive lighting. We do our best to stay on top of the latest LED technology to bring you the best, brightest LEDs available.
  • Automotive Kits

    There are multiple LEDs that will fit a particular application. We test each type of LED to ensure that that we offer the best possible solution for your needs.
  • Eco-friendly

    LEDs are better for the environment than regular bulbs. They use less energy and do not contain any hazardous materials or gasses..
  • LED Types

    Our LED lamps utilize standard miniature, high flux, high powered and ultra high powered LEDs.
  • Multiple Colors

    We offer 4 main colors to choose from. Most of our LED lamps come in white, blue, red and green colors.

Cart  

(empty)
CRUISE AND SUNROOF BUTTONS INSTALLATION GUIDE
94-97 Honda Accord

*Please read this all the way through before doing this install!*
We will not be held responsible for any mistakes, problems, or damage done to any part of your car. Follow this install guide carefully, and you should have no problems. If you are unsure about ANYTHING, please email us. We will help you out to the best of our ability.

Here Is What You Will Need:
- Phillips head screw driver
- Flat head screw driver

  The following items are not needed for solderless kits
- A fine point soldering iron ($8 - RadioShack part number: 64-2051)
- Solder (can be found at RadioShack for around $4)
- Crescent wrench

- Tweezers

To remove the button unit, use a flat head screw driver in the small slot at the bottom of the button unit and pry it out.


Bulb To LED Conversion (For LEDs that require soldering)
Click 
[here]  for the bulb to LED conversion instructions 


Installing the LEDs

These pictures show which side is + so you know where the anode (the lead with the resistor) should go. If any LEDs do not light up, simply rotate them 180 degrees and test again. The best way to rotate them is:
1. Unlock the LED and plastic base - approx 1/4 turn counter clockwise so it can be removed.
2. Pull the LED and base out of the hole just enough to turn it 1/2 a turn (180 degrees)
3. Put it back in the hole
4. Twist it to lock it in (approx 1/4 turn clockwise).


HomeHome