BLINKER INDICATOR INSTALLATION GUIDE 94-97 Honda Accord
*Please read this all the way through before doing this install!*
We will not be held responsible for any mistakes, problems, or damage done to any part of your car. Follow this install guide carefully, and you should have no problems. If you are unsure about ANYTHING, please email us. We will help you out to the best of our ability. |
Here Is What You Will Need: |
- Phillips head screw driver - Flat head screw driver
|
Follow the steps in the Gauge Cluster Install Guide to remove the gauge cluster.
To remove the white plastic cover from the back of the gauge cluster, remove the two screws holding it on. (Red circles in the picture below.) Also remove the bulb that has the wires coming out of it. (Blue arrow in the picture below.)
Now remove the 13 screws holding down the circuit board. Be careful not to move the gauge cluster around to much after removing the screws, they hold the gauges in place. Set the circuit board to the side.
Now you can see the bulb holders for the indicators. (Blinkers, check engine, SRS, high beams, seat belt, and e-brake.) Just remove the bulbs for the blinker indicators and install the LEDs.
Before putting everything back together, you have to test the LEDs. Reassemble the gauge cluster and plug the wire harnesses back in the cluster and make sure the dimmer button is also plugged in other wise no interior lights will turn on. If any of the LEDs do not light up, simply rotate them 180 degrees and test again. The best way to rotate it is: 1. Unlock the LED and plastic base - approx 1/4 turn counter clockwise so it can be removed. 2. Pull the LED and base out of the hole just enough to turn it 1/2 a turn (180 degrees) 3. Put it back in the hole 4. Twist it to lock it in (approx 1/4 turn clockwise).
|