LEDautomotive.com

  • LED Technology

    LEDs are the future of automotive lighting. We do our best to stay on top of the latest LED technology to bring you the best, brightest LEDs available.
  • Automotive Kits

    There are multiple LEDs that will fit a particular application. We test each type of LED to ensure that that we offer the best possible solution for your needs.
  • Eco-friendly

    LEDs are better for the environment than regular bulbs. They use less energy and do not contain any hazardous materials or gasses..
  • LED Types

    Our LED lamps utilize standard miniature, high flux, high powered and ultra high powered LEDs.
  • Multiple Colors

    We offer 4 main colors to choose from. Most of our LED lamps come in white, blue, red and green colors.

Cart  

(empty)
AUTOMATIC FLOOR SHIFTER INSTALLATION GUIDE
01-02 Honda Civic

*Please read this all the way through before doing this install!*
We will not be held responsible for any mistakes, problems, or damage done to any part of your car. Follow this install guide carefully, and you should have no problems. If you are unsure about ANYTHING, please email us. We will help you out to the best of our ability.

Here Is What You Will Need:
- Phillips head screw driver
- Flat head screw driver
- Teflon Tape


Remove the trim panel surrounding the e-brake with the square recess in it. It is held in by clips all around. Get your fingers under it as much as possible and pull till it comes off. Remove the 2 screws behind the shifter assembly as seen below.


Remove the expanding clips that hold the front of the center console in by reaching behind and pushing the middle pin out. (There is one on each side.)


With the seats as far forward as possible go behind the seats to remove the screws that are holding the rear of the console. (There is one on each side.)


Go back to the front of the car, sitting in the drivers seat. turn the car to the "on" position, depress the brake pedal, and move the shifter all the way back to "2". Remove the 2 screws on the front of the shifter. Take the shift knob off and set it aside.


Remove the center console by rotating the back upward. Pull the front back an inch or two and the console will be free to be pulled out, straight up.


On the drivers side of the shifter you will see a red and black wire going into the side of the shifter assembly. The the plastic at the end of the wires and turn it a 1/4 of a turn counter clockwise. Pull the light out. Place the LED in the holder where the light was. Put the light back in the socket and twits it into place.




Reassemble everything in reverse order.

 

HomeHome