FLOOR SHIFTERÂ INSTALLATION GUIDE 98-02 Honda Accord
*Please read this all the way through before doing this install!*
We will not be held responsible for any mistakes, problems, or damage done to any part of your car. Follow this install guide carefully, and you should have no problems. If you are unsure about ANYTHING, please email us. We will help you out to the best of our ability. |
Here Is What You Will Need: |
- A flat-head screwdriver |
The first thing we need to do is remove the cup holder. This is done by lifting straight up. It is just held in by a few clips.
Next we need to remove the trim piece around the shifter. You can use a flat head screw driver wrapped in some cloth so it doesn't scratch anything. You may also be able to use your hands to get this up. Just lift it up and out.
Lift up on the emergency brake.
Now we will take out the console trip piece. Start on the back, and lift straight up. The whole thing is held in by several clips. Lift up to unclip the two rear clips.
Next, lift straight up in the middle section to unclip the center set of clips.
Finally, lift straight up on the front of the piece to unclip the front set of clips. Start with the drivers side.
Then the passengers side.
Remove the console trim piece.
Here is a picture with everything removed
To the left you will see some wires going to the shift indicator. follow the wires to the bulb holder. Remove the bulb holder by twisting it 1/4 of a turn counter clockwise, and pulling straight out. Put the wedge LED in and test. If it does not light, turn the LED around. Once it is working, put it back in, This can be a little tricky, because you have to have the correct angle to put it back in.
Put everything back together in the reverse order.
|