Follow the steps in the Climate Control Install Guide [Here] to remove the trim piece and get to the gauge cluster.

Remove the 4 screws that hold in the gauge cluster

Pull the top of the gauge cluster toward you to reveal 3 wire harnesses. Disconnect the harnesses and remove the gauge cluster. If you have an alarm, the alarm computer will think the doors are closed once you remove the wire harnesses and the alarm will turn on. So have your keys handy.

Remove the bulbs shown by the red arrows in the picture below and install the smaller wedge LED that is included in the kit.

Remove the bulbs shown by the arrows in the picture below. Install a small wedge where the blue arrow is pointing and the larger radial LEDs in the locations designated by the red arrows.

Remove the two screws that are above the stereo holding in the climate control. You may have to remove the stereo. The picture below points to where the screws are located.

Now you have to test the gauge cluster. Reconnect the 3 wire harnesses and be sure you have the dimmer button connected and turn on the park lights. Determine which lights do not light up and take them out and turn them 180 degrees and try again. Once all the lights light up, reassemble everything in reverse order.

If you have any questions, feel free to email me at Nate@LEDautomotive.com.